DNF Controls 2034CL-Q - Manual (Page 15)

15 2034CL-Q, 300 Clip Instant Access System, Quantel Protocol
For Wheel only:
Press Softkey [PRSET] to select the SLOMO Preset Speed Mode.
Press Softkey [UPDATE].
When exiting SLOMO mode, the last used speed is saved in the Preset Speed register.
OR
Press Softkey [STATIC].
The Preset Speed register is NOT updated when exiting SLOMO mode.
It is only changed by [SHIFT] + [SLOMO] (PRESET SLOMO).
ST300
SETUP
Press Softkey beneath ClearCues to clear all Cue Points to 00:00:00:00.
Press Softkey [YES] when asked “Are You Sure?”
Press Softkey beneath SetDefault to set ST300 to default settings.
Press Softkey [YES] when asked “Are You Sure?”
IMPORTANT NOTE: Please set these items during initial installation.
DISPLAY
SOFTWARE
VERSION
The version number and date for the currently installed software is displayed. For example:
SYNC f Set to ON if black burst is supplied to the Ref Video connector on the rear panel. Set to OFF if no
blackburst is supplied.
RECORD Press Softkey to select single button or 2-button record.
RECORD = [REC] Only.
OR
[REC] + [PLAY].
4000CL-O V3.0
072400
ST300 SETUP
Clear Cues SetDefault