DNF Controls 2034CL-Q - Manual (Page 6)

6 2034CL-Q, 300 Clip Instant Access System, Quantel Protocol
4. VIDEO SERVER SETUP
Refer to Quantel Operators Manual. Set serial ports to the following format:
Baud Rate – 9600
Parity – None
Data Bits – 8
Stop Bits – 1
5. LOAD A CLIP
a.
Select a VTR by pressing VTR [1], VTR [2], VTR [3], or VTR [4].
b. Press
[CLIP LIST] to view the list of CLIP IDs that are resident on the Video Server.
The CLIP LIST indicator will turn on.
c. Press
[CREATE] to create and load a new clip.
(Creating a clip is described in the CREATING A CLIP section.)
OR
Turn the Wheel to view the existing CLIP IDs on the video server.
Turn the Wheel clockwise to scroll forward, or counter-clockwise to scroll backward,
through the list of available CLIPs. Backward scrolling is limited to the last 10 CLIP IDs
viewed.
OR
Manually enter a CLIP ID using the ST300 numeric keypad, or PC keyboard (if KBIO
option).
OR
Manually enter a Clip ID using the Qwerty keyboard on SHOTBOX.
d. Press [LOAD] to load the selected CLIP ID for playout.
If more than one Clip ID matches the entered/selected ID, the display will show “More
Than 1 Found.”
Using the wheel, scroll through the list of clips.
Select the desired clip, then press [LOAD].
e. Repeat steps a. thru d. to load clips on desired VTRs.
f.
Set the GANG mode, if required.
6. VIEW THE CLIP ID OF THE CURRENTLY LOADED
CLIP
Press [SHIFT] + [LOAD]. The bottom line will show the name of the loaded clip.