DNF Controls 2034CL-Q - Manual (Page 8)

8 2034CL-Q, 300 Clip Instant Access System, Quantel Protocol
8. RECALL A CLIP OR CLIP COMBINATION
a. RECALL ON THE SHOTBOX
1) Select the desired Bank.
2) Press the desired shotkey.
The ST300 will automatically load the learned clips on the learned VTRs, cue
the clips to the Learned time, then set the Learned Gang Mode.
b. RECALL ON THE ST300
1) Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE].
OR
By manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
2) Press
[LOAD] on the ST300.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue
the clips to the Learned time, then set the Learned GANG mode.
9. RECUE THE CURRENTLY LOADED CLIP
Press [RECUE]. If an IN Point is marked (the IN indicator is on), the clip will RECUE to the IN
Point.
If the IN point is not marked, the clip will RECUE to the start of the clip.
OR
Press [SHIFT] + [RECUE].
a.
Enter the desired time to search to using the ST300’s numeric keypad.
b. Press [ENTER] to search to the entered time.
OR
Press [ESC] to exit without searching.