DNF Controls 2034CL-Q - Manual (Page 7)

7 2034CL-Q, 300 Clip Instant Access System, Quantel Protocol
7. LEARN A CLIP OR CLIP COMBINATION
a. LEARN ON THE SHOTBOX
1)
Load a clip on the desired VTRs. (See Section 5, “LOAD A CLIP.”)
2) Press
[LEARN]. The LEARN indicator will turn on.
3)
Select the desired BANK and ShotKey.
4) Press
[LEARN] to exit at anytime.
NOTE: The [LEARN] key toggles LEARN mode on/off.
The controller will: LEARN (save) the VTR Number (1,2,3,4), loaded CLIP ID and
current IN time to the selected Cue Point.
b. LEARN ON THE ST300
1)
Load a clip on the desired VTRs. (See Section 5, “LOAD A CLIP.”)
2)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
3) Press [SHIFT] + [MARK] to initiate the LEARN.
The display will show:
4)
Press the VTR key desired: [1], [2], [3], [4].
5) Press [MARK] and the ST300 will:
LEARN (save) the VTR Number (1, 2, 3, 4), loaded CLIP ID and current
IN/OUT time to the selected Cue Point.
Press VTR:
MARK-Lrn ESC-Cancel