DNF Controls 2034CL-Q - Manual (Page 16)

16 2034CL-Q, 300 Clip Instant Access System, Quantel Protocol
17. FUNCTION TABLE
FUNCTION KEY PRESS DESCRIPTION
GOTO
ENTERED
TIME [SHIFT] + [RECUE] Search the VTR to the manually entered time.
Use the ST300 numeric keypad.
To manually enter the desired time press [ENTER] or [RECUE].
NOTE: G
RASS V ALLEY G ROUP Profile does not support TC or VITC
time search.
GANG [SHIFT]+[VTR #1]
OR
[SHIFT]+[VTR #2]
OR
[SHIFT]+[VTR #3]
OR
[SHIFT]+[VTR #4] Individually press the VTR keys to be included in the gang; the LED
above the key will turn on. Press the VTR key again to remove from
gang; the LED above the key will turn off. Press [ESC] to exit.
The VTR LEDs that are on show the gang.
The flashing LED shows which VTR is currently selected.
FFWD
[FFWD] Press and HOLD to FFWD. Release key to stop. Set WIND Speed in
MENU.
JOG [JOG] Select JOG mode and enable Wheel.
LAST CUE [LAST CUE] Step to the previous Cue Point Location.
LOOP [LOOP ENABLE] Play the currently loaded clip in a continuous loop.
NEXT CUE [NEXT CUE] Step to the next Cue Point Location.
RECORD [REC] Places VTR into the Record mode selected by RECORD MODE in the
SETUP MENU. Press [RECORD] or [RECORD] + [PLAY].
REWIND [RWD] Press and HOLD to REWIND. Release key to stop. Set WIND Speed
in MENU.
SHUTTLE [SHUTTLE] Select SHUTTLE mode and enable Wheel.
SLOMO [SLOMO] Press [SLOMO] to slo-mo the VTR. Turn the Wheel (or move the T-
Bar, if available) to change the play speed.
Press [SLOMO] to STILL frame
OR press any transport key to exit SLOMO.
SLO-MO
SPEED
PRESET [SHIFT] + [SLOMO] For WHEEL ONLY: Press [SHIFT] + [SLOMO] to preset the slo-mo
speed. Turn the Wheel to select desired speed.
Press [ESC] or any transport key to exit.
STOP [STOP] Press once to STILL frame VTR.
Press again to put VTR into STOP mode.