DNF Controls 2034CL-Q - Manual (Page 5)

5 2034CL-Q, 300 Clip Instant Access System, Quantel Protocol
3. SYSTEM INSTALLATION
a. SHOTBOX
1) Plug one end of a standard 9-pin, RS422 serial cable, into the
OUTPUT connector on the rear of the SHOTBOX. Plug the other end
of the cable into the AUX connector on the rear of the ST300.
2)
Connect the Ault Model #SW300 POWER SUPPLY into the POWER
connector on the rear of the SHOTBOX. Plug the Power Supply into an outlet,
90 VAC – 240 VAC.
b. ST300-S/SM, VTR/DDR CONTROLLER
1) Plug one end of a 9-conductor, RS422 serial cable into the VTR 1 (2, 3 or 4)
connector on the rear of the ST300. Plug the other end of the cable into the
REMOTE connector on the Video Server.
2) Connect the supplied POWER SUPPLY, APX#4108, into the POWER
connector on the rear of the ST300. Plug the Power Supply into an outlet, 90
VAC – 240 VAC.
3) Check SETUP MENU prior to using the ST300 to confirm proper Record mode
and other User settable modes.
Installation is complete.
CONNECTION DIAGRAM