Console layout (continued) – Diamondback Fitness 1000Sr User Manual
Page 18
19
Console Layout (Continued)
Press the
1.
USER ZONE key.
Press the
2.
ENTER key when the “USER SETUP” message comes on, in the message display.
Using either the
3.
UP or DOWN keys fi nd your profi le and press the ENTER key.
Press either the
4.
UP or DOWN keys until the message “REVIEW TOTALS” comes up.
Press the
5.
ENTER key.
At this point Use the
6.
UP and DOWN keys to review your workout data.
TOL TIME = XXXXHR
•
– this is the total time you have worked out in hours.
TOL CAL = XXXX
•
– this is the total calories burned since the user data was last cleared.
TOL DIS = XXX.XMI
•
– this is the total distance traveled since the user data was last cleared.
When the message
7.
“EXIT” comes up in the display press the ENTER key to exit from reviewing
your totals and reset the console to Idle mode.
Clear Totals
D.
To clear your user totals, follow the procedure below:
Press the
1.
USER ZONE key.
Press the
2.
ENTER key when the “USER SETUP” message comes on, in the message display.
Using either the
3.
UP or DOWN keys fi nd your profi le and press the ENTER key.
Press either the
4.
UP or DOWN keys until the message “CLEAR TOTALS” comes up.
The message
5.
“CLEAR TOTALS = YES” will come on with Yes blinking.
Press the
•
ENTER key when the Yes is blinking and the totals will reset to 0.
Use the
•
UP or DOWN keys to change the Yes to No. Pressing the Enter key when No is
blinking will not reset your totals.
After pressing the
6.
ENTER key the Console will also reset to Idle mode.
Measuring Units Setting
E.
The measuring unit can be changed between English and Metric.
Press the
1.
USER ZONE key.
When the
2.
“USER SETUP" message comes on in the message display; press either the UP or
DOWN key until the message “UNIT SETUP” comes up.
Press the
3.
ENTER Key. At this time the message display will display either “ENGLISH” or
“METRIC” depending on the settings of the console.
Press either
4.
UP or DOWN key to select the preferred measuring units.
Press the
5.
ENTER key. The measuring units will be changed and the console will reset to Idle
Mode.
Sound Setting
F.
The beeper on this units can be turned off and back on.
Press the
1.
USER ZONE key.
When the
2.
“USER SETUP” message comes on in the message display; press either UP or
DOWN key until the message “SOUND SETUP” comes up.
Press the
3.
ENTER Key. At this time the message display will display either “SOUND ON” or
“SOUND OFF” depending on the settings of the console.
Press either
4.
UP or DOWN key to select the preference.
Press the
5.
ENTER key. The console will stop or start beeping and reset to Idle mode.
1000Sr OM.indd 19
1000Sr OM.indd 19
7/7/2008 2:28:08 PM
7/7/2008 2:28:08 PM