DFI DT122-HR Manual - Manual (Page 68)

www.dfi .com
68
Chapter 10 Intel AMT Settings
Chapter 10
6. Select Change Intel(R) ME Password then press Enter.
You will be prompted for a password. The default password is “admin”. Enter the default
password in the space provided under Intel(R) ME New Password then press Enter.
• 8-32 characters
• Strong 7-bit ASCII characters excluding : , and ” characters
• At least one digit character (0, 1, ...9)
• At least one 7-bit ASCII non alpha-numeric character, above 0x20, (e.g. !, $, ;)
• Both lower case and upper case characters
7. Select FW Update Settings then press Enter.
[ESC] = Exit [ENTER] = Submit
[ INTEL(R) ME PLATFORM CONFIGURATION ]
Change Intel(R) ME Password
FW Update Settings 
Set PRTC
Power Control

Previous Menu
Intel(R) Management Engine BIOS Extension v7.0.0.0053/Intel(R) ME v7.0.4.1197
Copyright(C) 2003-09 Intel Corporation. All Rights Reserved.
Intel(R) ME New Password
[ESC] = Exit [ENTER] = Access [  ] = Select
[ INTEL(R) ME PLATFORM CONFIGURATION ]
Change Intel(R) ME Passowrd
FW Update Settings 
Set PRTC
Power Control

Previous Menu
Intel(R) Management Engine BIOS Extension v7.0.0.0053/Intel(R) ME v7.0.4.1197
Copyright(C) 2003-09 Intel Corporation. All Rights Reserved.
[ESC] = Exit [ENTER] = Access [  ] = Select
[ FW Update Settings ]
Intel(R) Management Engine BIOS Extension v7.0.0.0053/Intel(R) ME v7.0.4.1197
Copyright(C) 2003-09 Intel Corporation. All Rights Reserved.
Local FW Update
Previous Menu
[ ] Disabled
[*] Enabled
[ ] Password Protected
8. In the FW Update Settings menu, select Local FW Update then press Enter. Select
Disabled then press Enter.