DFI DT122-HR Manual - Manual (Page 47)

www.dfi .com
47
Chapter 7 BIOS Setup
Chapter 7
Display Present
Selects the display mode. The options are PCIe x16 and SDVO/HDMI/DP.
NB PCIe Configuration
Confi gure PEG0
B0: D1: F0 Gen1-Gen2
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
NB PCIe Confi guration
PEG0
Display Present
Not Present
[PCIe x16]
Chipset
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
DVMT Total Gfx Mem
This field is used to select the graphics memory size used by DVMT mode.
LCD Control
Select the Video Device
which will be activated
during POST. This has no
effect if external graphics
present.
Secondary boot display
selection will appear based
on your selection.
VGA modes will be sup-
ported only on primary
display.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1214. Copyright (C) 2011 American Megatrends, Inc.
LCD Control
Primary IGFX Boot Display
Secondary IGFX Boot Display
LCD Panel Type
[CRT]
[Disabled]
[VBIOS Default]
Chipset
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Primary IGFX Boot Display and Secondary IGFX Boot Display
The options are Disabled, CRT, EFP, LFP, EFP3 and EFP2.
LCD Panel Type
This field is used to select the type of LCD panel used by the internal graph-
ics device.