beautypg.com

Chapter 7 – DFI DT122-HR Manual User Manual

Page 40

background image

www.dfi .com

40

Chapter 7 BIOS Setup

Chapter 7

SATA Configuration

This section is used to configure SATA functions.

Enable or disable SATA
Device.

Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.

Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.

SATA Controller(s)
SATA Mode Selection

SATA Test Mode

Serial ATA Port 0
Software Preserve
Serial ATA Port 1
Software Preserve
Serial ATA Port 4
Software Preserve
Serial ATA Port 5
Software Preserve

Advanced

[Enabled]
[IDE]

[Disabled]

Empty
Unknown
Empty
Unknown
Empty
Unknown
Empty
Unknown



Select Screen



Select Item

Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous

Values

F3: Optimized

Defaults

F4: Save & Exit
ESC: Exit

SATA Controller(s)

This field is used to enable or disable the Serial ATA channels.

SATA Mode Selection

IDE Mode

This option configures the Serial ATA drives as Parallel ATA storage devices.
AHCI Mode

This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Inter-

face).
RAID Mode

This option allows you to create RAID or Intel Matrix Storage configuration on Serial ATA

devices.

SATA Test Mode

This field is used to enable or disable the Serial ATA test mode.

If AHCI or RAID is selected in the SATA Mode field, it will display the following information:

Determines how SATA
controller(s) operate.

Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.

Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.

SATA Controller(s)

SATA Mode Selection

Software Feature Mask Confi guration

Serial ATA Port 0
Software Preserve

Port 0

Hot Plug
External SATA
SATA Device Type

Serial ATA Port 1
Software Preserve

Port 1
Hot Plug
External SATA
SATA Device Type

Serial ATA Port 4
Software Preserve

Port 4

Hot Plug
External SATA
SATA Device Type

Serial ATA Port 5
Software Preserve

Port 5

Hot Plug
External SATA
SATA Device Type

Advanced

[Enabled]

[RAID]

Empty
Unknown

[Enabled]
[Disabled]
[Disabled]
[Hard Disk Driver]

Empty
Unknown

[Enabled]
[Disabled]
[Disabled]
[Hard Disk Driver]

Empty
Unknown

[Enabled]
[Disabled]
[Disabled]
[Hard Disk Driver]

Empty
Unknown

[Enabled]
[Disabled]
[Disabled]
[Hard Disk Driver]



Select Screen



Select Item

Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous

Values

F3: Optimized

Defaults

F4: Save & Exit
ESC: Exit

Serial ATA Port 0 to Serial ATA Port 5

These fields are used to configure the connected SATA devices.