Datatek HP-UX 10.20 (32 bit kernel - Manual (Page 5)

I P - C o m m K i t I n s t a l l a t i o n a n d A d m i n i s t r a t i o n G u i d e
f o r H P - U X – I s s u e 2 – R e l e a s e 1 . 0 . 2 2
10/13/11 Datatek Applications Inc. 5
2 D O C U M E N T A T I O N
Since IP-CommKit behaves like a CommKit Host Interface, you can use the CommKit Host
Interface documentation to find answers to most questions. Specifically, use the CommKit Host
Interface for NCR PCI Computers Installation and Administration Guide. This document follows
the same general outline, i.e., it has the same major sections in the same order. Where there are
changes or additions for IP-CommKit, they are described in the appropriate section of this
document. While NCR computers running MP-RAS are very different from HP  computers
running HP-UX, IP-CommKit is built from source code that was ported from the release of the
CommKit Host Interface that ran on NCR computers. As a result, much of the information in the
CommKit Host Interface for NCR PCI Computers Installation and Administration Guide applies to
IP-CommKit running on HP computers.
 HP-UX and HP are registered trademarks of Hewlett Packard, Inc. Systems Division.