Datatek HP-UX 10.20 (32 bit kernel - Manual (Page 30)

I P - C o m m K i t I n s t a l l a t i o n a n d A d m i n i s t r a t i o n G u i d e
f o r H P - U X – I s s u e 2 – R e l e a s e 1 . 0 . 2 2
10/13/11 Datatek Applications Inc. 30
6.2.4 P ING THE UTM FROM THE HOST
On the host computer, enter the following command:
$ ping utm_ip_address
In this command, utm_ip_address is the IP address that you assigned to the UTM module. The
output should be similar to the report below:
utm_ip_address is alive
If you do not get this output, then the host and UTM cannot exchange packets. In this case, the
report would appear as follows:
no answer from utm_ip_address
If you get this output, check that you are using the correct UTM IP address. If you are, you
should enlist the aid of you IP network administrator. Don’t proceed until you can ping the UTM
from the host.
6.2.5 C HECK / VAR / OPT / DK / DKIPDLOG
Enter the following command on the host computer:
$ tail /var/opt/dk/log/dkipdlog