Datatek HP-UX 10.20 (32 bit kernel - Manual (Page 18)

I P - C o m m K i t I n s t a l l a t i o n a n d A d m i n i s t r a t i o n G u i d e
f o r H P - U X – I s s u e 2 – R e l e a s e 1 . 0 . 2 2
10/13/11 Datatek Applications Inc. 18
# swinstall -s /tmp/ipcommkit IPCOMMKIT
Your host is now configured to start the IP-CommKit software automatically at boot time. You can
reboot your host now, but you will need to register your copy of the software and configure your
control tables before you can use IP-CommKit. To reboot your host, enter the following
commands:
# cd /
# shutdown –y –r now
3.5.4 R EGISTRATION
Starting with revision 1.0.12, the IP-CommKit software is copy-protected. You must obtain a
software key and register your copy of the software before you can use IP-CommKit.
Here is how the registration process works: When you purchase IP-CommKit, we provide you
with a software certificate number. For example, here is the software certificate number for the
IP-CommKit software running on one of my development machines:
20HP11113-000670-U6CU
If you received your software on a CD, the software certificate number is included in the package.
If the software was delivered electronically, the software certificate number is included in the e-
mail message. In either case, you must save the software certificate number since it serves as
your proof of purchase.
After installing the IP-CommKit software on your host computer, contact us to obtain a software
key. To generate your software key, we need your software certificate number and the
nodename of the host on which the software is installed. To determine the nodename, enter the
following command on the host:
$ uname -n