Datatek HP-UX 10.20 (32 bit kernel - Manual (Page 36)

I P - C o m m K i t I n s t a l l a t i o n a n d A d m i n i s t r a t i o n G u i d e
f o r H P - U X – I s s u e 2 – R e l e a s e 1 . 0 . 2 2
10/13/11 Datatek Applications Inc. 36
00-12-19 17:16:42 NODE=node_name
M verify address all server_name
MNEMONIC ADDRESS: server_name X.121 NANP ADDRESS:
LEVEL: local SERVICE STATE: in
PAD SUPPORT: no
DIRECTORY: none
SECURITY: none
GROUP: group_name
If the report indicates that the address has not been entered, enter it using the instructions in the
BNS Node Configuration section of this document. If the report shows that the address is out of
service, restore the address with the following command:
CC0> res addr local server_name
When dkserver starts, it tells the BNS node that it is ready to accept incoming calls. You can
confirm this by entering the follow command on the BNS node console:
CC0> disp conn mod mod_address