Dataprobe iBootBar User Manual
Page 31

iBootBar V1.5x
Page 31
SNMP
Up to four SNMP managers can be set. Each manager will receive Trap notifications for outlet changes, autoping and
current alarms. Set the SNMP manager IP addresses using the
set snmp
command.
Enable or Disable SNMP for any manager with the
set snmp
command. The MIB is available on the
distribution CD, or at
http://Dataprobe.com/ibootbartools.html
The iBootBar also supports the following elements of MIB-II
mgmt [1.3.6.1.2]
|
-> [ 1] -BR- mib-2
|
-> [ 1] -BR- system
|
-> [ 1] *RO* DisplayString
sysDescr
-> [ 2] *RO* OBJECT IDENTIFIER
sysObjectID
-> [ 3] *RO* TimeTicks
sysUpTime
-> [ 4] *RW* DisplayString
sysContact
Truncated to 128 Char
-> [ 5] *RW* DisplayString
sysName
Truncated to 128 Char
-> [ 6] *RW* DisplayString
sysLocation
Truncated to 128 Char
-> [ 7] *RO* INTEGER
sysServices
Firmware Upgrades
The iBootBar can be upgraded via the network if the upload feature has been enabled using the
set upload enable yes
command on the console interface. To upgrade the iBootBar download the latest version of the firmware and upgrade
utility from the Dataprobe website.
http://Dataprobe.com/ibootbartools.html
Password Recovery
Holding the reset button on the front panel of the iBootBar for 5 seconds or longer will initiate a password recovery
mode. Once the reset button is released, the user has 30 seconds to log in to the CLI using the username
admin
and
password
admin
. Upon accessing the CLI, change the username and password for User 1 as desired.