beautypg.com

Dataprobe iBootBar User Manual

Page 19

background image



iBootBar V1.5x

Page 19

get console 

Displays the current console configuration, Timeout and Baud Rate

Yes

set console timeout <30‐3600/disable> 

Console can be set to automatically logout with no activity for 30 seconds to 1 hr in
seconds, or disabled.

Yes 120

set console baudrate 
<400/4800/9600/19200/38400/ 57600/115200> 

The baud rate of the serial port. 400,4800,9600,19200 ,38400,57600,115200 bps

Yes

115200

get modem 

Gets the current settings of the modem. –M models only.

Yes

set modem countrycode  

Sets the modem country code. –M models only.

See page 34 for a list of country codes.

Yes 181

(USA)

set device <0‐16> 

Get / Set the device ID for cluster applications. A device ID of 0 for single iBootBar
applications. A device ID of 1 makes the unit a master, and a device ID of 2-16 make
the iBB a remote in cluster configurations. These commands are only valid when
directly connected to the iBootBar, rather than as remote units in a cluster.

Yes 0

get device 

set unit  device <2‐16> 

Sets the ID of a remote device in cluster configurations. The harware key

is

the last 2 bytes of the MAC address NO spaces, dashes or colons.

  

Yes

set factory defaults 

Resets all parameters to their factory settings including the IP Address. Only available
on the serial port. Confirmation is required. Note: This command can take up to 30
seconds to execute.

Yes

logout 

Ends the session

No

reboot 

Reboots the selected iBootBar. This will not change the status of the outlets of
standalone or Master of cluster configuration (device ID 0 or 1). May cause outlet
changes in expansion units (device ID 2-16)

Yes

In this example, the

 

is 38A2

This manual is related to the following products: