beautypg.com

Dataprobe iBootBar User Manual

Page 12

background image



Page 12

iBootBar V1.5x

Setting the IP address from a DHCP Server
A DHCP server will automatically assign an IP address (dynamic address) as well as Subnet Mask and Gateway to the
iBootBar.

To enable this feature, configure the iBootBar with the command

set ipmode dhcp 

Then reboot the iBootBar, or enter the command

reboot


To find the IP address of the iBootBar you will need to query your DHCP server and locate the MAC address of the
iBootBar in the DHCP server’s IP / MAC table. You can also access the CLI and use the

get network

command, or use

the Discover provision of the iBootBar Setup and Control Utility.

 

Setting the IP address using ARP / Ping


The ARP / Ping technique uses a PC running a command line (DOS Window) to set the IP Address. To set the IP
address using ARP, connect the iBootBar to your local network and apply power. The IP address to be assigned to
iBootBar must be use the same subnet as the computer assigning the address. ARP does not work across routed or
switched networks.

To set the IP address using ARP, the hardware (MAC) address must be known. This address is located on the bottom
of the unit. The syntax for the MAC address is: nn-nn-nn-nn-nn-nn

Windows (98 and Later)

1.

Access the iBootBar CLI and enter the

set ipmode arp‐ping 

command

2.

On a PC, open a DOS window. (Run: Command)

3.

Type the following command:

arp -s

Where is the desired IP address (in dotted decimal) for the iBootBar and the is
the MAC Address of the iBootBar. The MAC Address of the iBootBar is located on the rear of the unit.

Example: arp -s 63.211.86.165 00-50-c2-05-01-c1

|new IP addr| |---MAC addr----|

4.

Ping the iBootBar to program the IP address into the iBootBar.

Type: ping

Note: If the ping command returns “host not responding” 4 times then the address has not been programmed

properly. Check the IP or MAC Address for typographical errors. Repeat step 2. If the problem
persists, contact the Dataprobe Tech Support.

5.

Delete the entry from the ARP cache by typing:

arp -d

6.

Ping the iBootBar to confirm that it has been programmed.

If the iBootBar fails to respond, repeat steps 2-4 above. If the problem persists, contact Dataprobe Tech
Support.


Unix, Linux, MAC and others

Consult your systems administrator for information on how to set an IP Address. The unit should be pinged after the IP
Address has been set to confirm proper operation.

Other Configuration Settings


All parameters are set using the CLI. See Page 16 for a complete list.

This manual is related to the following products: