Timed events – Dataprobe iBootBar User Manual
Page 27

iBootBar V1.5x
Page 27
Timed Events
The iBootBar provides the ability to turn On, Off or Cycle outlets based on time and date. Each individual outlet or group
can be set to operate a selected command at a specific time and date. The Timed Events are programmed thru the
Control & Setup Utility or the CLI interface. Up to 16 events can be created.
Each event can be assigned to one outlet or group and repeated on a regular basis.
Administrative rights are required to set up and manage any event. To add an event, create the event, assign the event
to a specific outlet or group and then configure the initial occurrence of the event, the action to be performed, and the
repeat frequency, if desired.
To configure the timed events, use the following commands:
get events
get event
add event
dev event
ren event
set event
set event < eventname> month <1‐12>
set event
set event
set event
set event
set event
set event
set event
set event