Dataprobe iBootBar - Manual (Page 29)

iBootBar V1.5x
Page 29
CLI Operation and Setup:
To view the status of any of the AutoPing channels, issue the
get autoping <1‐16> command.
iBootBar > get autoping 1
IP Address: 192.168.1.7
Action: Cycle
Frequency: 30
Count: 3
Outlet: Cabinet_1 ‐ Firewall
Status: OK
OK
iBootBar >
To configure the AutoPing, use the following commands:
set autoping <1‐16> ipaddress
set autoping <1‐16> action
set autoping <1‐16> frequency <1‐999>
set autoping <1‐16> count <1‐99>
set autoping <1‐16> device outlet <1‐8>
set autoping <1‐16> group