Daktronics AF-3165-34-RGB - Manual (Page 43)

Maintenance and Troubleshooting 39
Removing the Louver Assembly
Complete the following steps to remove the
louver assembly from the face of the module:
1. From the backside of the module,
remove the five twist-on fasteners
holding the louver assembly to the
module.
2. Lift the louver assembly straight
away from the module.
Damaged louvers may reduce the brightness
and contrast of this display. If any of the
louvers on the display are broken or
damaged, the entire louver assembly must be
replaced. Refer to the Replacement Parts
List in Section 4.11. When replacing the
louver assembly take care not to strip the
plastic twist-on fasteners.
Figure 35: Removing a Module