Daktronics AF-3165-34-RGB - Manual (Page 24)

Electrical Installation 20
J-Box to Signal Term Panel (A35)
J-box Wire Color Signal Term
Panel (TB1)
Pin 1 (TX-P) Black Pin 1 (RX1)
Pin 2 (RX-P) Clear or Red Pin 2 (TX1)
Pin 3 (GND) Shield Pin 3 (GND)
RS-422
A display that is controlled using RS-422 requires the use of Signal Converter near the computer. From
the Signal converter cable is run to the Signal termination Panel in the display or to a plug that is
connected to the Quick Connect at the display. The cable from the signal converter to the display must
be routed though conduit. Do not run signal and display power through the same conduit. Refer to
Drawing A-174135 for system layout.
1. If using a quick connect cable, connect from the Signal Converter to J32 on the back of the
display.
2. When connecting directly to the display, terminate one end at Signal converter and the other
end of the wire to the 6-position terminal block in the display labeled “RS422 IN” (A35-
TB2). Drawing B-175387 shows the terminal block wiring.
Figure 22: RS232 Signal Term Panel