Delta Electronics Delta Temperature Controller DTC1000R - Manual (Page 8)

Delta Temperature Controller User Manual
2007-09-17 - 8 - © DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
Display Explanations
PV SV Status of the temperature controller
Press “down” key continuously until the value reaches 1357
(please DO NOT modify this value; otherwise system confusion
may occur)
.
＋
Press the two keys together once to return to main screen.
Main screen
Switch off DTB
and re-power
it.
Return to default value. The default sensor is PT100, which will be
displayed when DTB is not connected to a sensor or
thermocouple.
The model adopted in this example is: DTB4896RR with firmware V1.50.
1. Make sure RS-485 hardware communication cable in DTB has been connected to the computer.
2. Make sure the communication parameters in DTB are consistent with those in the computer.
Display Explanations
PV SV Status of the temperature controller
Example displayed value
Press for
more than 3
seconds to enter
initial setting
mode
Example displayed value: PT100 Sensor
Press
continuously for
10 times
ON/OFF of communication write-in