Delta Electronics Delta Temperature Controller DTC1000R - Manual (Page 21)

Delta Temperature Controller User Manual
© DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED - 21 - 2007-09-17
Display Explanations
PV SV Status of the temperature controller
Set up the position of decimal point
Key-locked function
Output volume. In PID PROG control mode, this is a read-only
parameter and cannot be modified.
CHAPTER 4:
C
ONTROL
M
ODES IN
D
TC
4.1 ON/OFF
There are four control modes in DTC: ON/OFF, MANUAL, PID and PID PROG. Due to that DTC has
no display panel, the settings and monitoring of parameters have to rely on communication.
Therefore, you have to check the following 2 items to ensure normal communication.
1. Make sure RS-485 hardware communication cable in DTC has been connected to the computer.
2. Make sure the communication parameters in DTC are consistent with those in the computer.
Next, open DTCOM Software and switch to ON/OFF control mode.