Comtech EF Data ROSS - Manual (Page 65)

ROSS MN/13070
To properly set the corresponding LO frequency value, the network administrator will be
required to consult the antenna manufactures set voltage/tone tables to determine the correct LO
frequency. After determining the LO frequency, apply this frequency value to the Local
Oscillator field and enable the down converter as indicated below.
As previously mentioned the set values within the service area will be pushed to the VMS for
updating of the remote down/up converter conversions.
Down converter configuration for multiband
LNB control. Converter Type must also match
that of the shipboard equipment installed.
Refer to VMS Users Guide for additional information on configuring converter operations.
Comtech EF Data, Vipersat Products Page 65 of 87