Comtech EF Data ROSS - Manual (Page 32)

ROSS MN/13070
Reset - Restore System to Factory Settings
Revert - Last Changed Parameters
Save - All Changed Parameters
1. Enter ACU type string. This is specific to each ACU vendor. See appendices for more
information.
2. Enter the ACU Config using the format for the specific ACU vendor.
3. Select Ok to enter changes, Cancel will disregard entries
4.7 Modem Configuration
This sets the IP address that ROSS will use to communicate with the locally attached Comtech
modem. The modem IP address information is obtainable from the front panel of the modem, see
specific users guide for menu operation. After selecting Ok the ROSS will initialize polling with
inquires of modem SOTM mode, enabled/disabled and set SAT ID number.
Comtech EF Data, Vipersat Products Page 32 of 87