Comtech EF Data ROSS - Manual (Page 15)

ROSS MN/13070
2 Installation Overview
This section provides the steps necessary to install the ROSS unit as part of the remote terminal
equipment in a Vipersat SOTM network. Any additional noncompliant third party equipment is
not described in this document for clarity.
2.1 Installation Requirements
The document assumes that the ACU and all its supporting equipment have been installed and
configured.
Hardware:
• ROSS Unit
• CDM-570L or SLM-5650A Satellite Modem & Router
• Installed ACU (including all below & above deck equipment)
Software:
• ROSS Configuration Editor, v1.3.0.921
• SetIP LAN Configuration Utility, v1.0
• VLoad 3.5.39 or later
• Putty v0.60
• ACU configuration application (depends on ACU vendor)
Documentation:
• ROSS User Guide, MN/13070, r4
• CDM-570/570L Installation and Operation Manual,
MN/22125
• SLM-5650A User Guide, MN-0000035
• ACU Installation and Operation Manual, see vendor’s for part numbers
2.2 Unpacking and Inspection
Inspect the shipping container for any evidence of damage. If any damage is found, notify the
carrier in case a claim may have to be filed. This will only be necessary should the contents also
be found to be damaged.
Unpack the equipment from the container. Retain all shipping materials for future use, such as
for reshipment or RMA service. Visually inspect the equipment for any possible damage
incurred during shipment.
Check the equipment against the packing list to ensure that the shipment is complete. Should any
items be found to be either missing or damaged, contact customer support to report and record
before proceeding forward.
Comtech EF Data, Vipersat Products Page 15 of 87