Comtech EF Data Vipersat Load Utility v3.5.x - Manual (Page 89)

Chapter 4 - Using VLoad — Digicast Mode 4-19
Digicast Media Router Remote Commander
Adding a PID
Figure 4-20 Digicast Add PID dialog
PID ID – The identifier for the PID on the receiver. The PID ID is the how to
address the PID from this application to the receiver.
PID Name – A user defined identifier.
PID Value – The value of the PID in hexadecimal format.
VLAN ID – Allows the user to set the Virtual Local Area Network ID to one of
the following: None, All, 4094.
Mode – Allows the user to set the Mode to either Multiprotocol Encapsulation /
Internet Protocol(MPE/IP) or Digital Video Broadcasting - Transport Stream
(DVB-TS).
Destination IP Address – The IP address to be used when routing the Trans-
port Stream over the Ethernet IP.
Port – The Port Number used when routing the Transport Stream over the
Ethernet IP.