Actions area on the remote commander, Reset, Actions area on the remote commander . 4-9 – Comtech EF Data Vipersat Load Utility v3.5.x User Manual

Page 79: Reset -9, Figure 4-11 digicast actions box -9

Chapter 4 - Using VLoad — Digicast Mode

4-9

Digicast Media Router Remote Commander

Actions Area on the Remote Commander

Figure 4-11 Digicast Actions box

• Reset – Reboots the receivers that are selected in the receiver listing.
• Tuner – updates either the Primary or Secondary Tuner settings on the

selected receivers.

• Firmware – Updates either the Application or FPGA code on the selected

receivers.

• PID – Creates, updates or deletes the PID settings on the selected

receivers.

The list of affected receivers can be selective by checking the individual receiv-

ers in the receiver list or by selecting Update all units, which sends out a global

broadcast.

Reset

The Reset dialog differentiates from the other commands in that it does not

allow multiple passes for the reset command. The reset command is sent out

only once per command transfer attempt.