Comtech EF Data Vipersat Load Utility v3.5.x - Manual (Page 63)

Chapter 3 - Using VLoad — Vipersat Mode 3-39
Base Modem Mode
Base Modem Mode
Selecting the Base Modem radio button in the Mode Selection box, shown in
figure 3-36, sets VLoad to act on the base modem firmware running on the unit.
Figure 3-36 Base Modem Mode Selection
This mode is used to Put and/or Select the base modem image to/for the unit(s).
Note that the Get capability is not available in this mode.
Note: Button captions displayed and functions available for all modes are
controlled by the Mode selected from the Mode Selection radio buttons,
the selected Preference, as well as the Type of modem unit that is
selected from the Unit List.
File Selection
When performing a Put action, the base modem .bin file must first be selected.
By default, VLoad will automatically select the previous base modem .bin file
that was last Put to a modem. Use the File Selection Browse button to locate
another file, or a file that is stored in another directory. Alternatively, the path
for the desired file can be entered directly using the keyboard.
NOTE