Put application / codecast application, Put application / codecast application 3-27, In figure 3-22. th – Comtech EF Data Vipersat Load Utility v3.5.x User Manual
Page 51

Chapter 3 - Using VLoad — Vipersat Mode
3-27
Application Mode
Figure 3-22 Get Application Progress Status
When the transfer is successful, VLoad invokes a Save As file dialog, allowing
a name and path to be chosen for storing the .bin file. If saved, the appearance of
the progress bar will change to Green to indicate that the operation was success-
ful. If the file is not saved, the progress bar will change to Orange and the staus
text will state that the operation was completed, but the file was not saved.
Figure 3-23 Get Completed, File Not Saved
Put Application / Codecast Application
Clicking the Put Application / Codecast Application button displays the
dialog window shown in figure 3-24.
Note: The files put by the Put Application command are only put to the
modem’s Vipersat router board. Refer to the “Base Modem Mode”
section on page 3-39 for putting files to the base modem portion of the
modem.
This function is operable for either a single unit or multiple units. If multiple
units are selected for a Put Application, the Same For All Selected Units check
box will appear, providing the option to perform the Put to the group using the
same specified settings.
NOTE