Comtech EF Data Vipersat Load Utility v3.5.x - Manual (Page 58)

Configuration Mode
3-34 VLoad User Guide
If a valid file is not currently selected, this button will be grayed out.
Either browse to locate a valid file, or first perform a Get Configuration
operation on a modem unit that has the appropriate file.
Note: For new modem types that have not yet been predefined in VLoad, file
validation can be inhibited by setting the Preferences to Unrestricted.
Using this preference in Configuration Mode will allow any param file to
be Put to any modem type. See the “Unrestricted” section on page 3-7
for more information.
• Edit Param File – This action opens the Parameter Editor window for
making configuration changes to the param file that can then be Put to a
modem. The Edit Param File button is enabled whenever the File
Selection is valid and a ParamEdit.dll file for that version of parameter file
exists in the VLoad directory; no unit selection is required since this
function operates on a file that is in the network directory.
Get Configuration
Clicking the Get Configuration button displays the Get Configuration From
Unit dialog window shown in figure 3-30.
Figure 3-30 Get Configuration dialog
The Get Configuration function is only operable for one unit at a time, so only
one modem can be selected from the unit list.
Specify a Transfer Rate (Kbps) between 1 and 9980 Kbps which will transfer
the data error-free, or use the default value of 900 Kbps.
Select either Active or Flash as the From radio button, depending on whether
the configuration will be retrieved from the Active memory or the Flash
memory of the unit.
Clicking the OK button sets the values to be used and initiates the Get action.
The Progress area of the main window will display the transfer progress status
NOTE