Digicast receivers area on the remote commander, Delete, Select all – Comtech EF Data Vipersat Load Utility v3.5.x User Manual

Page 74: Update all, Receiver listing, Checkbox, Digicast receivers area on the remote, Commander -4

Digicast Media Router Remote Commander

4-4

VLoad User Guide

Digicast Receivers Area on the Remote Commander

Figure 4-4 Digicast Receivers Listing / Selection box

Add

Opens a dialogue that allows the user to add a receiver to the list below shown

in 3.1.1. This is required for individual addressing of remote commands.

Delete

Removes the selected receiver from the list.

Select All

Selects or unselects all receivers on the list.

Update All

Forces all receivers listening on the configured multicast address and PID to

respond to a remote command.

Receiver Listing

Receivers are identified by their MAC address. Other information can be

entered to assist in identifying the receiver.

Checkbox

Receivers are selected with a single left-click on the checkbox to the left of the

MAC address of the receiver.