Comtech EF Data CMR-5970 Manual - Manual (Page 64)

Digicast Media Router S2 Receiver CMR-5970 (MR-S2) & CMR-5990 (MR-S2-ASI) Revision A
Device Management via User Interfaces MN/MRS2ASIDC.IOM
The user may navigate the menus in the same manner as the Terminal Interface. With
specific exceptions as noted in the Terminal Interface section, the menus available via
Telnet and Serial interfac
4.5 T rivial
es are identical.
File Transfer Protocol (TFTP)
The MR-S2 supports changes to the resident software and firmware by means of the
Trivial File Transfer Protocol (TFTP). This enables changes to be made remotely via the
LAN interface. It is recommended to use Solarwinds TFTP server application (available
SelectProgramFree.cfm at http://support.solarwinds.net/updates/ ).
y ’. Set up the location
of the MR-S2 files.
e ‘ Transmit and
Receive ’ are selected.
The ser
for the file transfer process.
o modify co
To modify the software and/or firmware, use the following procedures:
Configure the server as follows:
a) File ! Configuration ! Select the ‘ TFTP Root Director
b) File ! Configuration ! Select the ‘ Security ’ tab and make sur
c) Save configuration.
ver is now configured
Because the MR
T
de via Telnet:
Step Procedure
1 d
previously.
ode provided by CEFD is located in the TFTP Root
directory.
when new code is provided)
server and wait for the message
ss any key to continue”
This code modif
nder the
Administration
Start up Solarwinds TFTP server – Ensure configuration as describe
2 Ensure that the c
3 Start up Telnet client and initiate a session with the MR-S2 as described
in the Telnet Interface section
4 Select
5
‘A’ for Administration
Select ‘D’ for Download
6 Enter ‘1’ for Application code or ‘2’ for FPGA code (the user will be
directed to select Application or FPGA code in the download
instructions provided by CEFD
7 Enter the IP address of the TFTP
“Upgrade complete. Pre
ication process can also be conducted via the Web Interface, u
page, or the Terminal Interface under the Main Menu.
IMPORTANT
Do
NOT remove power from the unit durin
-S2 stops processing data traffic during the
cess, it is recommended that this upgrade procedure
be performed during scheduled network down time.
g the download process.
download pro
4-38