Comtech EF Data CMR-5970 Manual - Manual (Page 35)

Digicast Media Router S2 Receiver CMR-5970 (MR-S2) & CMR-5990 (MR-S2-ASI) Revision A
Device Management via User Interfaces MN/MRS2ASIDC.IOM
4.2.7 MPE/IP Configuration (Tuner or MR-S2-ASI only)
a) Full page with ASI Input Port selected
b) Page headers with TUNER Input Port selected
Figure 4-9. MPE/IP Configuration page (Tuner or MR-S2-ASI only)
On this page, from the pull down, the user must select for which input interface
the PIDs will be configured for MPE/IP. For the MR-S2 there is no pull down,
but for the MR-S2-ASI, the user can select which interface (Tuner or ASI) to
configure.
PID Address
A configured PID value in hexadecimal, for MPE/IP data to be extracted from
the transport stream and sent to the CPU. Once a valid PID value is configured,
once data is found on a transport stream, the data is decapsulated and delivered to
the Ethernet port. Note, the pull down menu allows the user to select which input
port (ASI input or Tuner) the PIDs are being received from. A value of 0x1FFF
is disabled.
4-9