Comtech EF Data CMR-5970 Manual - Manual (Page 34)

Digicast Media Router S2 Receiver CMR-5970 (MR-S2) & CMR-5990 (MR-S2-ASI) Revision A
Device Management via User Interfaces MN/MRS2ASIDC.IOM
4.2.6 Unicast Routing Configuration
Figure 4-8. Unicast Routing Configuration page
The Unicast Routing Configuration page addresses the PID Filter’s configuration for
handling Unicast traffic over the transport stream. This feature is only used in the
MPE/IP configuration.
Allow Unicast
Selects whether the PID Filter will support the routing of Unicast traffic.
Route unknown to default gateway
If an Address Resolution Protocol (ARP) can not be achieved, then incoming
Unicast is directed to the configured default gateway.
Filter on TSD MAC (MPE/IP)
Allows the PID Filter to route only Unicast that is specifically destined to this
unit. The MAC address in the MPE header must exactly match the configured
TSD MAC field.
TSD MAC (MPE/IP)
The hardware Media Access Control (MAC) address assigned for Unicast
operation.
4-8