Comtech EF Data DMDVR20 LBST Rev 1.1 - Manual (Page 95)

Appendix B DMDVR20 LBST Satellite Modem
B-4 TM136 – Rev. 1.1
2. Contact Radyne with the Unit ID and Request a Demonstration.
The modem’s Unit ID can be found on the front panel as follows:
a. From the modem’s Main Menu, scroll right to the SYSTEM Menu.
b. Scroll down.
c. Scroll right to the HW/FW CONFIG Menu.
d. Scroll down.
e. Scroll right to the FEATURES Menu.
f. Scroll down.
The value displayed on the top line of this menu is the 12-digit Unit ID. It is displayed as
on the front panel of the modem as 3 sets of 4 digits in a dot-delineated format as follows:
1 2 3 4 . 1 2 3 4 . 1 2 3 4
Your Radyne sales representative will ask you for this number along with the features
you wish to demo.
3.
Once your order has been processed, you will be issued a 12-digit demonstration code.
This code can only be used one time and it is only good on the modem for which it was
originally requested. To enter this code from the front panel, perform the following:
a. From the modem’s Main Menu, scroll right to the SYSTEM Menu.
b. Scroll down.
c. Scroll right to the HW/FW CONFIG Menu.
d. Scroll down.
e. Scroll right to the FEATURES Menu.
f. Scroll down.
The value displayed on the top line of this menu is the 12-digit Unit ID. It is displayed on
the front panel of the modem as 3 sets of 4 digits. The second line is the data entry area
and is displayed as 3 sets of 4 underscores in a dot-delineated format.
Press and a cursor will begin flashing in the data entry area
Using the numeric keypad, enter your 12-digit demonstration code
Press .
If the code entered is correct, the display will display CODE ACCEPTED, otherwise the
display will read INVALID CODE.
Care should be taken to insure that the demonstration code is entered
properly. After three unsuccessful attempts to enter a code, the front
panel upgrade and demonstration capability will be locked out and it will
be necessary to cycle power on the modem in order to continue.