Comtech EF Data DMDVR20 LBST Rev 1.1 - Manual (Page 93)

Appendix B DMDVR20 LBST Satellite Modem
B-2 TM136 – Rev. 1.1
2. Contact Radyne with the Unit ID and Desired Upgrades. The modem’s Unit ID can be
found on the front panel as follows:
a. From the modem’s Main Menu, scroll right to the SYSTEM Menu.
b. Scroll down.
c. Scroll right to the HW/FW CONFIG Menu.
d. Scroll down.
e. Scroll right to the FEATURES Menu.
f. Scroll down
The value displayed on the top line of this menu is the 12-digit Unit ID. It is displayed as
on the front panel of the modem as 3 sets of 4 digits in a dot-delineated format as follows:
1 2 3 4 . 1 2 3 4 . 1 2 3 4
Your Radyne sales representative will ask you for this number along with your desired
feature set upgrades when placing your order.
3.
Once your order has been processed, you will be issued a 12-digit feature set upgrade
code. This code is only good on the modem for which it was ordered. To enter this code
from the front panel, perform the following:
a. From the modem’s Main Menu, scroll right to the SYSTEM Menu.
b. Scroll down.
c. Scroll right to the HW/FW CONFIG Menu.
d. Scroll down.
e. Scroll right to the FEATURES Menu.
f. Scroll down.
The value displayed on the top line of this menu is the 12-digit Unit ID. It is displayed on
the front panel of the modem as 3 sets of 4 digits in a dot-delineated format indicated in
Step 2. The second line is the data entry area and is displayed as 3 sets of 4
underscores in a dot-delineated format.
g.
Press . A cursor will begin flashing in the data entry area.
h. Using the numeric keypad, enter your 12-digit upgrade code.
i. Press .
If the code entered is correct, the display will display CODE ACCEPTED, otherwise the
INVALID CODE will be displayed.
Care should be taken to insure that the upgrade code is entered properly.
After three unsuccessful attempts to enter a code, the front panel
upgrade and demonstration capability will be locked out and it will be
necessary to cycle power on the modem in order to continue.