Comtech EF Data DMDVR20 LBST Rev 1.1 - Manual (Page 63)

User Interfaces DMDVR20 LBST Satellite Modem
4-26 TM136 – Rev. 1.1
MODEM EADDR {001065010000}
Displays the Ethernet address of the device. Set at the
factory and is a unique identifier for the Ethernet physical
interface.
ETHER
RATE {10 MBPS/HD}
The data rate for the local Ethernet Interface.
10 Mbps/HD – for 10 Base-T in either half-duplex or full
duplex.
HW/FW CONFIG (menu)
FIRMWARE
REV Displays the installed firmware revision.
M&C
REV Displays the installed Monitor and Control revision.
MAIN BOARD (menu)
Only the appropriate of the VCO adjustment screens listed below will be
displayed. These are protected fields, to prohibit accidental changes. To
edit the field, the user must depress all four of the direction arrow keys
simultaneously.
INT VCO ADJUST {0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed of the system
reference clock is INTERNAL.
HI STAB VCO ADJUST {0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.
LARGEST
HB GAP Used for factory test only.
CLEAR USER NV {Enter}
SOFT RESET {Enter}
IF BOARD (menu) Indicates the Radyne part number for the IF Board
Assembly.
AGC/CTRL/VALUE
{0% - 100%}
Allows the user to adjust the internal frequency
reference for calibration. Only displayed if the system
reference clock source is HI STABILITY.