Code Blue IP1500 VOIP SPEAKERPHONE - Manual (Page 40)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-137-E page 40 of 66
IP1500 and IP2500 Series
Administrator Guide
ACTION SCRIPT PARAMETERS
Within the Scripts are many settings controlling the next step in the process of the Action Script: Du-
ration of the process, Enable/Disable features, or even a reactivation of an Aux Output with a timed
limitation. The following will provide detailed explanations into these Script controls.
Note: Scripts, Phone Numbers and Recordings all share a 1Mb memory cap.
Playing a Message
Messages can be set to play any time upon the activation of a Script or during a call.
Plus, they can be set to repeat as shown here:
Place Call
Placing a Call is where the administrator sets up which numbers will be attempted and the order.
The administrator could choose multiple numbers stored in “Numbers” or the same number can be
repeated many times. “If not answered, then” Call. Select additional numbers to be dialed.
Dialing/Answer Timeout: The default time is 60 seconds and can be stepped down to as little as
five seconds, before the call attempt times out.
Maximum Call Duration: The default time is 600 seconds (10 minutes). Duration range 0001 to
9999 seconds (1 second up to 166.65 minutes). Thirty seconds before the timer exhausts an audible
tone will play to notify both parties the call is about to terminate, unless the timer is disabled through
a During call Command (DTMF tone 3).
While Dialing: Standard Ringback is the default setting. Other choices: A message can be set to
play to the person at the IP1500/2500 and/or Do Nothing, until the call is connected.
(Continued on next page)