Code Blue CB 1-E ECONOMICAL HELP POINT - Manual (Page 41)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-157-E page 41 of 71
CB 1 Series
Administrator Guide
4.5 Attach the phone wires from the GSM assembly to terminals 1 and 2 on the IA4100
4 pin connector.
4.6 Set up GSM card. Refer to GSM digital set up instructions.
5.0 CONNECT THE POWER WIRES
5.1 Make the connections – First, locate the grounding lug and connect the ground wire,
leaving a minimum of six inches of slack. Second, using #8 forks, connect the power
wires.
5.2 Using 115V AC supply: Connect the colored (hot) wire to the terminal screw furthest
to the left (#1) on the terminal strip. Connect the white (neutral) wire to the terminal
screw second to the left (#2) on the terminal strip.
5.3 Higher voltage supply: If the unit was ordered for a higher voltage, a multi-tap trans-
former will be located at the top of the electrical panel. Be sure to connect your power
wires to the correct terminal screws on the top of the transformer as labeled. Complete
the connection by attaching the terminal cover that is supplied.
IMPORTANT: If the power is applied to the incorrect terminal screws, damage will occur to
the unit. This damage will NOT be covered by any Code Blue warranty.
6.0 INSTALL THE BATTERY
IMPORTANT: Batteries MUST be fully bench charged before installation.
6.1 Place the battery into the unit – The battery should be placed in the bottom of the unit
(in a CB 1 or CB 9 unit the battery shelf will need to be set in place first).
6.2 Connect the wires – First connect the blue wire to the positive lug on the battery, then
connect the black wire to the negative lug.
7.0 APPLY POWER
7.1 Once power is applied, the unit will start the charging process.