Code Blue CB 1-E ECONOMICAL HELP POINT - Manual (Page 30)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-157-E page 30 of 71
CB 1 Series
Administrator Guide
One battery should be placed on each shelf.
4.2
Connect The Wires – First connect the red wire to the positive (+) lugs on the batteries, then
connect the black wire to the negative (-) lugs.
WARNING: Reversing the battery wires (reversed polarity) will cause damage to the charge
controller.
CELLULAR RETRO INSTRUCTIONS
TELULAR SX-5E & CALLFINDER CX100FX2 TO GSM-4
Installation Instructions
Retrofit Instructions Telular & CallFinder
We strongly advise reading these instruction before any work is started. In addition, the age of these
units is possible the actual wiring may have changed by others, therefore the wiring guides provided
are originals and here for your reference.
Some early 2002 designs: a total rebuild is more effective and easier to accomplish. Contact customer
service a rebuild kit.
Telular GSM Removal Instructions Specifically
Current Installations: If you still have a Telular cellular F.C.T. (Fixed Cellular Terminal),
inside your CB1 NightCharge™ or CB1w (Solar), CB8 NightCharge™ or CB8 Solar
enclosure, it is a hardwired internal harness. The wiring in the enclosure is bundled;
therefore removing two wires from the bundled group is very time consuming. You
may choose to reuse existing wiring, cutting and splicing the power wires is accept-
able, if doing so, use self-sealing splices.
Consideration: abandoning the original power wires will require you to identify the
harness and power panel in order to properly attach the new GSM-4 power wires.
Review the list below for the most common configurations.
Hint: Cellular power terminate on the same buss as the Battery.
Models involved in this Retro – Visual Refer document Attached
CB1 CB8
D and S NightCharge™ 2002, 2005, 20t10 NightCharge™ 2002, 2005, 2010
W Solar 2005, 2008, 2010 - 2013 Solar 2005, 2008, 2010 - 2013