Cadac LIVE1 - Manual (Page 4)

4
Revision L1.1 2011-12 Live1
GENERAL PRECAUTIONS
• Do not place heavy objects on the control surface, expose it to sharp
objects or handle the console in any way that may cause damage e.g.
rough handling and/or excessive vibration.
• Do not subject the equipment to dirt, dust, heat or vibration during operation
or storage. Never expose the console to rain or moisture in any form.
Should the console become wet, turn it off and disconnect from mains
without further delay. The console should be given suffi cient time to dry out,
before recommencing operation.
• When cleaning the console, never use chemicals, abrasive substances or
solvents.
• The console control panel should be cleaned using a soft brush and a dry
lint-free cloth. For persistent marks, use a soft cloth and isopropyl alcohol.
Switches and potentiometers do NOT require cleaning or lubrication.
• Keep these instructions for future reference. Follow all warnings in this
manual and those printed on the console.
• The console must be connected following the guidance in this manual.
Never connect power amplifi er outputs directly to the console. Connectors
and plugs must never be used for any other purpose than that for which
they are intended.
• The PSU mains input must always be connected to correctly rated mains
power as referred to in this manual. The mains input must, at all times, be
connected to the local mains power supply using the supplied power cord.
In cases where the supplied plug does not fi t, a qualifi ed electrician must be
consulted.
• The power cord must be routed in such a way that the risks of accidentally
stepping on it, stretching it or it being pinched, are minimized.
• WARNING ! THIS EQUIPMENT MUST BE EARTHED !
• Ventilation slots must never be covered or in any other way obstructed. Air
fl ow required for safe operation may otherwise be restricted. Where the
console is to be operated in its fl ight-case, then this must be located in such
a way that it allows for proper ventilation.
• Refer servicing to qualifi ed technical personnel only.