Cadac LIVE1 - Manual (Page 23)

Revision L1.1 2011-12 Live1
23
Monitoring of stereo channels may be either pre-fade (PFL) or after-fade (AFL);
the mode is selected globally from the Master section (see “AFL Mode” on page
29). In PFL mode, the signal heard is a mono sum of the L and R legs, and
the channel fader and MUTE button have no effect on the level. In AFL mode,
the full stereo signal is heard, (as modifi ed by the BAL control); the channel
fader setting will affect the level of the signal heard, but the MUTE button will
have no effect.
Fader section:
Scribble strip
– a writing strip is provided to allow channel identifi cation. The
stereo channels are designated ST1 to ST4.
M – Pressing the M (MUTE) button mutes all outputs from the channel: via the
subgroup and master routing, all auxiliary sends, and any AFL monitoring. The
sole exception is PFL monitoring, which remains active. An adjacent red LED
illuminates to confi rm that MUTE is applied.
Signal level LEDs – three LEDs indicate the signal level, post-EQ, pre-insert, as
follows:
red: +12 dBu
yellow: 0 dBu
yellow: -12 dBu
The LEDs indicate a mono sum of the left and right legs.
Fader – a 100 mm plastic conductive fader with a red knob adjusts the overall
stereo channel level.