Bronkhorst DeviceNet slave interface User Manual

Page 7

BRONKHORST

Page 7

DeviceNet interface

9.17.026

1.4 S

HORT FORM START

‐

All necessary settings for this module are already performed at Bronkhorst.
To follow next steps carefully is the quickest way to get this module operational in your own DeviceNet environment.

START

Master

present

Load EDS

Make sure your master has been installed to the DeviceNet system

Load EDS‐file with configuration tool

Copy bitmaps

Bitmaps (with flow controllers) can be copied in the proper directory (mostly
automatic, sometimes by hand; depends on program)

Add slave to DeviceNet

system

Select "Bronkhorst meter/controller" and add new instrument to the bus

Set device configuration

Set parameter data

Set parameter data for a‐cyclic setting of parameter values

Set MAC ID and baud rate

of instrument:

Default instruments will be delivered to customers on address 63 and with a
baud rate of 125000 baud. Normally setting an address can be performed by
your master configuration software.
However, if you choose to set a station address off‐line you can use the
programme FLOWFIX to change MAC ID and baud rate via RS232
connection. MAC ID and baud rate can also be changed by using the button
on top of the instrument or the rotary switches on the side of the
instrument if present. See chapter 8 for more details.