Bronkhorst DeviceNet slave interface - Manual (Page 24)

BRONKHORST ®
Page 24 DeviceNet interface 9.17.026
4.2.2 Setpoint
For the objects Analog Sensor and Single Stage Controller, the following data types and data units are supported for
Value and alarm levels. Note that data type and data unit can only be changed when not in executing mode. The
followings data units are supported (dependent on sensor type, actual sensor type can be found in calibration sheet):
Sensortype Supported units
0 (pressure) 0x1001 (counts)
0x1007 (percentage) [not for Sensor value]
0x1300 (psi)
0x1301 (Torr)
0x1303 (mm Hg)
0x1305 (cm H
2
O)
0x1307 (bar)
0x1308 (mbar)
0x1309 (Pa)
0x130A (kPa)
0x130B (atm)
0x130C (gf/cm
2
)
0x0800 (cm Hg)
0x0801(kgf/cm
2 )
1 (liq. Volume) 0x1001 (counts)
0x1007 (percentage) [not for Sensor value]
0x0900 (l/min)
0x0901 (ml/h)
0x0902 (ml/min)
0x0903 (l/h)
0x0904 (mm
3
/s)
0x0905 (cm 3 /min)
2 (mass flow) 0x1001 (counts)
0x1007 (percentage) [not for Sensor value]
0x1404 (kg/s)
0x140E (mg/min)
0x140F (g/min)
0x1410 (kg/h)
0x0A00 (kg/min)
0x0A01 (g/h)
0x0A02 (g/s)
0x0A03 (mg/h)
0x0A04 (mg/s)
3 (gas volume) 0x1001 (counts)
0x1007 (percentage) [not for Sensor value]
0x1400 (sccm)
0x1401 (slm)
0x0B00 (ln/min)
0x0B01 (mln/h)
0x0B02 (mln/min)
0x0B03 (ln/h)
0x0B04 (m
3 n/h)
0x0B05 (mls/min)
0x0B06 (mls/h)
0x0B07 (ls/h)
0x0B08 (m
3
s/h)
0x0B09 (ls/min)
4 (other) 0x1001 (counts)
0x1007 (percentage) [not for Sensor value]
5 (temperature) 0x1001 (counts)
0x1007 (percentage) [not for Sensor value]
0x1200 (deg. C)
0x1201 (deg. F)
0x1202 (K)
The following data types are supported:
0xC3 (int) 0xCA (real)