Bronkhorst LIQUI-FLOW mini (from 01-07-2013) - Manual (Page 8)

LIQUI-FLOW™ mini 9.17.065
Bronkhorst High-Tech BV
8
2.5 Leak check
Check the system for leaks before applying (fluid) pressure. Especially if toxic or other dangerous fluids are used!
2.6 Electrical connection
Electrical connections must be made with a standard cable or according to the LIQUI-FLOW TM mini hook-up diagram.
Several hook-up examples and standard cables are found in section 3.
LIQUI-FLOW TM mini instruments are powered with +15…+24 Vdc.
i
www
Electrical connections must be made with standard cables or according to the applicable hook-up diagrams. These
documents can be found at: http://www.bronkhorst.com/en/downloads
The instruments contain electronic components that are susceptible to damage by electrostatic discharge. Proper
handling procedures must be taken during installation, removing and connecting the electronics.
The instruments described in this manual carry the CE-mark and are complient with the EMC requirements.
However compliance with the EMC requirements is not possible without the use of proper cables and connector/
gland assemblies. Bronkhorst High-Tech B.V. recommends the use of their standard cables. These cables have the
right connectors and if loose ends are used, these will be marked to prevent wrong connection. When using other
cables, cable wire diameters should be sufficient to carry the supply current and voltage losses must be kept as low
as possible. When in doubt: contact your distributor.
When connecting the system to other devices (e.g. to PLC), be sure that the integrity of the shielding is not affected.
Do not use unshielded wire terminals.
2.7 Hook-up diagram