Bronkhorst IQ+FLOW (till 01-07-2013) - Manual (Page 2)

9.17.045 page 2
Disclaimer
Even though care has been taken in the preparation and publication of the contents of this manual, we do not assume
legal or other liability for any inaccuracy, mistake, mis-statement or any other error of whatsoever nature contained
herein. The material in this manual is for information purposes only, and is subject to change without notice.
Bronkhorst High-Tech B.V.
January 2013
Symbols
Important information. Discarding this information could cause injuries to people or damage to the
Instrument or installation.
Helpful information. This information will facilitate the use of this instrument.
Additional info available on the internet or from your local sales representative.
Receipt of equipment
Check the outside packing box for damage incurred during shipment. Should the packing box be damaged, then the
local carrier must be notified at once regarding his liability, if so required. At the same time a report should be
submitted to your distributor.
Carefully remove the equipment from the packing box. Verify that the equipment was not damaged during shipment.
Should the equipment be damaged, then the local carrier must be notified at once regarding his liability, if so required.
At the same time a report should be submitted to your distributor.
Before installing an IQ + FLOW® instrument it is important to read the attached labels and check:
- Instrument type
- Flow rate
- Fluid to be measured/controlled
- Up- and downstream pressure
- Input and output signal
- Temperature
Do not discard spare or replacement parts with the packing material and inspect the contents for
damaged or missing parts.
Refer to chapter 6 about return shipment procedures.
Equipment storage
The equipment should be stored in its original packing in a cupboard warehouse or similar. Care should be taken not
to subject the equipment to excessive temperatures or humidity.