Beisler 1911-4 - Manual (Page 78)

Short Seam Automat 1911-4 / 1912-4 Working Instructions
- D 78 -
Beisler Automated Sewing Equipment
D.3
Programming
D.3.4 Global parameters
No. Programmable global parameters (F2)
01
CLAMP FWD TO PART:
Scanning and piece pick-up after clamp movement forward / time interval
02
TILL CLAMP DOWN ......:
Lower clamp after clamp movement forward for piece pick-up / time interval
03
TILL VACUUM OFF ......:
Vacuum off after clamp down / time interval
04
THREAD LENGTH:
Load bobbin full
05
TILL CLAMP INSERTING:
Clamp insertion delay / time delay
06
SEWING END ->CL.SIDEW.:
Clamp movement rearward sideways after sewing drive off / time interval
07
TIME AFTER CLAMP OPEN:
Clamp movement right to programmed position after clamp up / time interval
17
TILL TENSION OPEN ....:
Tension blowing on after end of seam / time interval
18
DURATION OF TENS. OPEN:
ON duration for tension blowing
19
TILL THREAD CLAMP FORW.:
Time until thread clamp forward and blowing on after clamp up / time interval
20
DUR.THREAD CLAMP FORW.:
Duration of blowing and thread clamp forward
29
TILL SWING RETAINER DWN.:
Lower ejector stamp after end of sem / time interval
30
TILL RETAINER SWINGS:
Retract ejector stamp after stamp is lowered / time interval
31
DUR.OF PULLING RETAINER:
Retract ejector stamp and raise stamp / duration
32
BLOW OUT THE PART ....:
Blow off sewing pieces / duration
33
CLAMP MOVES TO STACKER:
Transportation of the sewing pieces / duration
35
THREAD CATCH. "UP" POS:
Thread lever in top position / duration
36
SWITCH ON POS. OF TRIMM.:
Switch-on position for thread cutting: Input value of 01-255
37
TRIMMING SPEED ......:
Speed during thread cutting
38
DURATION OF TRIMMING:
ON duration for thread cutting
39
THREAD CATCH. TURNS BACK:
Thread lever reversing angle
40
PROCESS IN STEPS .....:
Gradual machine cycle