Beisler 1911-4 - Manual (Page 66)

Short Seam Automat 1911-4 / 1912-4 Working Instructions
- D 66 -
Beisler Automated Sewing Equipment
D.3
Programming
D.3.1 System menu
Move clamp by hand. If the numeric value (mm) changes,
the sensor is operational.
• Press
key exit menu.
Setting clamp travel steps
Switch machine on and allow to reference (perform RE-
SET) (see also Service Instructions, Section C.5.4).
• Press
key.
• Press
key (diagnostics).
• Press
% key.
• Press key (clamp transport).
• Press
% key.
• Press
key (clamp motor steps).
• Press
% key.
Set travel steps using reference switch SO4:
• at switch 820mm
• right stop 50 mm
Displaying total piece counter:
With this counter, the total number of finished pieces can
be displayed. The counter cannot be reset.
• Press
key.
• Press key (additional programs).
• Press
key (piece counter).
The number of pieces : 0000000 is displayed.
• Press
key exit menu.
Eprom seam parameters:
Use this function to copy the factory-programmed fixed
seams from the Eprom back to the sewing program.
• Press
key.
• Press
key (init parameters).
• Press key (Eprom seam parameters).
• Enter seam number using numeric keypad.