Beisler 1911-4 - Manual (Page 25)

- B 25 -
Short Seam Automat 1911-4 / 1912-4 Working Instructions Beisler Automated Sewing Equipment
Alternatively, mode 01 can be controlled as follows:
1. Depress footswitch for machine operation and keep de-
pressed:
• The vacuum is switched on.
2. Release footswitch:
• The holding stamp is lowered.
3. Depress footswitch and keep depressed:
• The main clamp picks up the sewing piece.
• Further machine cycle is automatic. When the main
clamp moves to the sewing head, the footswitch
can be released.
NOTE - Supplying sewing pieces!
When the sewing piece is transported to the sewing head,
the next piece can be lined up.
The footswitch remains deactivated until the main clamp
reaches its start position and the stop rail moves forward;
after that, the next machine cycle can be started.
Controlling machine cycle in mode 02:
1. Line up sewing piece.
2. Depress footswitch for machine operation and keep de-
pressed:
• The vacuum is switched on.
3. Release footswitch:
• The holding stamp is lowered, the sewing piece is
picked up by the main clamp.
4. For each further operational step of the machine, de-
press footswitch.
NOTE - Supplying sewing pieces!
When the sewing piece is transported to the sewing head,
the next piece can be lined up.
B.3.10 Resetting line-up process
This function depends on the selected machine cycle
mode. It refers only to machine movements that can be
executed before the start of the automatic process.
The machine movements can be reset graduallydurch den
The machine movements can be reset immediately to the
original position by using the activation command.
• Press
key (several times if required).
"
B.3
Operation
B.3.9 Starting machine cycle
A machine cycle can be started in three different sequences
(mode 00, mode 01, mode 02). The factory default is mode
01 which allows a largely fully automatic machine cycle.
Controlling machine cycle in mode 00
(fast version):
1. Line up sewing piece.
2. Depress footswitch for machine operation and keep de-
pressed:
• The vacuum is switched on
3. Release footswitch:
• The holding stamp is lowered.
• Further machine cycle is fully automatic:
The main clamp picks up the sewing piece and trans-
ports it to the sewing head. The sewing piece is
tucked and ejected. The main clamp returns to the
start position. The next machine cycle starts.
NOTE - Supplying sewing pieces!
If the fully automatic machine cycle was started, the next
sewing pieces can be lined up.
The footswitch remains deactivated until the main clamp
reaches its start position and the stop rail moves forward;
after that, the next machine cycle can be started.
Controlling machine cycle in mode 01
(slow version):
1. Line up sewing piece.
2. Depress footswitch for machine operation and keep de-
pressed:
• The vacuum is switched on.
3. Release footswitch:
• The holding stamp is lowered.
4. Depress, then release footswitch:
• The main clamp picks up the sewing piece.
5. Depress, then release footswitch:
• Further machine cycle is fully automatic:
The main clamp picks up the sewing piece and trans-
ports it to the sewing head. The sewing piece is
tucked and ejected. The main clamp returns to the
start position. The next machine cycle starts.